Measure and Install No-Drill Motorized Roller Shades

Please note that we only make your product to the dimensions you specify, with no additions made.

Instructions For No-Drill Inside Mount Roller Shades
Inside-mounted fit inside the window casing. Please note we only offer standard window sizes blinds which cannot fit special-shaped windows.

• Measuring the width: The width measurement of roller shades is taken from the inside edge of the window frame at the top. Always measure to the nearest ⅛’’, and be sure to use a steel measuring tape. Your order width=Your window width-1/2’’.
• Measuring the depth: Your window needs to be deep enough for an inside mount. The minimum depth for inside mount is 2.7’’.
• Measuring the height: The height measurement of roller shades is taken from the window frame in three places, top left, center, and top right down to the sill. Record the tallest height up to the nearest ⅛’’. This will be the height you order.

Please note: The fabric width will be slightly narrower than the headrail width (roughly a ½’’ gap on each side). The gap is required in order for the shades to operate properly. Most customers are OK with this, but if you want to block more light and have more privacy, consider an outside mount with extra width, or other products such as blackout cellular shades.

Instructions For Outside Drill Mount Roller Shades

Outside-mounted roller shades hang above the window, or on the wall surrounding the window.

• Measuring the width: Take the measurement at the top of the window frame. You’ll use that measurement and add the recommended 2 to 4 inches. This will ensure the window is properly covered. For more light coverage and privacy, add even more to the measurement.
• Measuring the height: Take it from three locations, left, center, and right. You’ll use the tallest height and add the recommended 2 to 4 inches. This will ensure the window is properly covered.

How to Install Motorized Roller Shades (No-Drill for inside mount)

Step 1: Snap the spring mechanism on the left side of the roller shade into the left side of the wall.

Step 2: Snap/push the right side into the wall.

Step 3: Adjust the position and tighten the left-side small hole with the provided fixing screw to adjust the spring tension.

How to Install Motorized Roller Shades (Drill for outside mount)

Installation parts for roller shades including mounting brackets, screws, and remote (for both inside and outside mount)

Step 1. Bracket location and installation.

Step 2. Mounting the shade.

Step 3. Directly operate with the pre-programmed remote, or connect Tuya/Smart Life app for automation and voice commands if you’ve purchased the smart control options.